那是甚麼驕傲阿 就是去人家家裡學人家五十年前做的事情怎麼做罷了 The main orbiter communications system was a two-way, S-band, high-rate radio link providing Earth command, radio tracking and science and engineering data return. This link used either a steerable 1.5-meter(59-inch) dish high-gain antenna or an omni-directional low-gain antenna, both of them on the orbiter.The low-gain antenna was used to send and receive near Earth, and the high-gain antenna was used as the orbiter journeyed farther from Earth. S-band transmission rates varied from 8.3 or 33.3bits per second for engineering data to 2,000 to16,000 bits per second for lander and orbiter science data. Relay from the lander was achieved through an antenna mounted on the outer edge of a solar panel. It was activated before separation and received from the lander through separation, entry, landing and surface operations. The bit rate during entry and landing was 4,000 bits per second; landed rate was 16,000 bits per second. Data were stored aboard the orbiter on two eight-track digital tape recorders. Seven tracks were used for picture data and the eighth track for infrared data or relayed lander data. Each recorder could store 640million bits.Data collected by the orbiter, including lander data, were converted into digital form by the flight data subsystem and routed to the communications subsystem for transmission or to the tape recorders for storage. This subsystem also provided timing signals for the three orbiter science experiments.
These first images are low-resolution versions known as “thumbnails.” https://blogs.nasa.gov/mars2020/2021/02/18/blog-first-image-from-perseverance-on-mars/