• 2

2007 Q7 4.2FSI 怪毛病

兩周內發生兩次

第一次- 開的好好的, 停在路邊, 熄火抽菸, 然後要發就再也發不動了. 不是電池沒電的發不動. 用key轉,整個儀錶版都不會亮燈, 然後key轉下去, 啟動馬達也沒有反應.... 然後修車行換了顆電瓶,編了碼, 撇了12張小朋友.

8天之後, 就是昨天, 同樣情況再度發生.....這次真的無言了....

(其實我感覺就是電腦or某處秀斗....絕對不是電池or 發電機問題).

請問站上的大大有人碰過此種狀況嗎???

謝謝
2017-06-12 16:36 發佈
文章關鍵字 毛病 2007 4.2
jpm.michael wrote:
兩周內發生兩次第一次...(恕刪)

啟動開關間隙過大或接觸不良導致儀錶指示燈不亮,車輛無法啟動
感謝! 但是用Keyless 也沒辦法發動. 儀錶板上一個燈都不會亮.
點火系統有檢查過嗎?~~~~
jpm.michael wrote:
感謝! 但是用Key...(恕刪)

請問這狀況發生前有維修過或改裝過什么東西嗎?還是有發生過事故,依你敘述不管用機械鑰匙或免鑰匙系統都會發生無法啟動,且儀錶指示燈也不亮,可能是中繼接頭或搭鐵接觸不良,或保險絲盒電源接觸不良
jpm.michael wrote:
兩周內發生兩次第一...(恕刪)

hall sensor NG.
不想花錢開引擎蓋散熱就好了
查到故障碼如下 , 請問該怎麼修呢??? (上次換電瓶看來是打水漂了, 這次不想白花錢了..)


00288 - Steering Column Lock Actuator (N360)

00288 - Steering Column Lock Actuator (N360): No Signal

00288 - Steering Column Lock Actuator (N360): Implausible signal

00288 - Steering Column Lock Actuator (N360): Open Circuit

00288 - Steering Column Lock Actuator (N360):Open Circuit / Short to ground

00288 - Steering Column Lock Actuator (N360): Open Circuit / Short to positive

00288 - Steering Column Lock Actuator (N360): Electrical fault in Circuit

00288 - Steering Column Lock Actuator (N360): Defective

Possible Symptoms
Ignition power will NOT switch on
Steering column will or will not lock

Possible Causes
Wiring/Connections from/to N360
Faulty N360

Possible Solutions
Check wiring/connections from/to N360
Check/Replace failed N360

Special Notes
If the ignition will not switch on, the communication with the Access Start controller still maybe possible, Try this: Turn on the hazards, press the brake pedal and hold the flash to pass
This will wake-up(activate) the CAN-Bus and may allow limited communication to the vehicle
If present clear the N360 fault code and if the vehicle's ignition power is now active, suspect a failed N360.

When found in the Volkswagen Passat 3C, please see this page VW Passat (3C) Immobilizer
When found on the Audi A6/S6/RS6/allroad (4F) the N360 is part of the steering column and is not available separately from the Audi at this time.
See TSB / TPI 2040593 for possible part/software update when found in Audi Q7 and A6 (2005 to 2014).
Vehicles equipped with Immobilizer 4C or higher will require an online connection with VW/Audi/Bentley to correctly adapt the new N360 to the vehicle. erWin offers some Immobilizer and Pass-Thru solutions which are mentioned under the notes section of our Official Factory Repair Information page.
Replacement with a used N360 is not supported.





Category: Fault Codes
jpm.michael wrote:
查到故障碼如下 , ...(恕刪)

是轉向機柱鎖正極或負極,開路或短路,此零件與轉向柱為一並供應,原廠無供應分件,建議你先回原廠詢問是否與軟體更新有關,也需更新後可解決問題
感謝大大的建議!!!
15151515
jpm.michael wrote:
感謝大大的建議!!!...(恕刪)

不客氣,那是轉述你提供的英文故障碼訊息的大致內容,到時回原廠時,也請提供他們參考,祝你早日修復愛車,記得要分享哦
  • 2
內文搜尋
X
評分
評分
複製連結
Mobile01提醒您
您目前瀏覽的是行動版網頁
是否切換到電腦版網頁呢?