• 4

[求救]Apple TV 2G JB不了…


搞了十幾個小時,
跟英文網頁戰了數百回合,
不知是我理解能力太差,還是真的技術門檻太高…

我還是沒法順利把我新入手的APPLE TV JB…

請求版上神人可否指點一下…

目前用的工具程式:

AppleTV2,1_4.2.1_8C154_Custom_Restore
PwnageTool_4.1.3_Unlock_Edition
tethered


到底該如何是好啊~~~~~~~

((系統已升為4.2))

麻煩各位~~
★這傢洗艾台玩啦!☆
2010-12-24 3:57 發佈
我也無法成功,卡在回復custom 韌体apple驗證那邊,使用imac 失敗

改用win7 在做一次,出現itunes錯誤3194....

有人可以幫忙嗎?

我的apple tv2昨天有更新了軔體,好像是4.1.1
說不定是因為這樣所以無法破解?

版上真的沒人JB成功的嗎?!

T_T…
★這傢洗艾台玩啦!☆
點此
裡面有句話
All you’ll have to do is to use new PwnageTool bundle to jailbreak iOS 4.2.1 instead of iOS 4.2 PwageTool bundle.

或許可以試試看,我昨天也是剛開箱apple tv,糊塗糊塗也把os升了4.1.1(本來是4.0),不過現在我手邊沒有micro usb的線,沒辦法實驗jb,若有是成功再跟大家說一下。

我這兩天一直在試JB…

後來發現

我都是在

8. Run the following commands in terminal:

cd ~/desktop/tethered

./tetheredboot -i iBSS.k66ap.RELEASE.dfu -k kernelcache.release.k66

NOTE: it will loop a complaint re: DFU mode, just ignore this, once you are finished getting in DFU mode tetheredboot will take over.

9. MANUALLY put the AppleTV in DFU (*DO NOT USE PWNAGETOOL*)

- Disconnect power cable and connect your Apple TV with your computer via microUSB
- Now reboot your Apple TV by holding down Menu + Down buttons together for around 6 seconds.
- After reboot, immediately hold Menu + Play until you see the message in iTunes saying that Apple TV in recovery mode is detected



這兩個步驟出了問題…

尤其是紅字的部分!

不曉得有沒有大大可以用中文解釋一下呢?

我怕我英文程度不夠,對這兩點的理解有所不同…

謝謝…
★這傢洗艾台玩啦!☆
我是在剛買時的軔體 AppleTV2,1_4.1_8M89_Restore.ipsw 完成破解的

後來為了AirPlay升到4.2

最近比較忙 就沒有在玩

新版軔體還沒時間破...

-------------------------------------------------------------
關於第9點

以手動方式使ATV 2G進入DFU

將電源線拔除後 透過microUSB連接電腦與ATV 2G

同時按下"Menu"與"向下"鍵約6秒

這時會從原本約1秒閃1下的狀態-->熄掉-->又亮起來(即重新開機了)-->

立刻放掉"Menu"與"向下"鍵-->再立刻按住"Menu"與"play"鍵直到

iTunes偵測到ATV 2G進入回復模式

--------------------------------------------------------------

按住"Menu"與"向下"鍵那6秒可以感覺一下燈號的節奏

不然 youtube上應該也有不少教學了

看一下先吧

Try it!
我jb成功了,手法應該跟你一樣~提供給你參考

之前也是升級到4.1.1的軟體版本

./tetheredboot -i iBSS.k66ap.RELEASE.dfu -k kernelcache.release.k66
之後按enter~
會出現

Waiting for device to enter DFU mode
opening device 05ac:1281...
Setting to configuration 1
Setting to interface 0:0
Device must be in DFU mode to continue

就是顯示沒有進入DFU MODE~

此時快點apple remote的MENU和PLAY一起按~約五秒鐘
apple tv的閃燈就會變超快的~顯示已經進入了dfu了
接下來就會顯示這些~

Found device in DFU mode
Checking if device is compatible with this jailbreak
Checking the device type
Identified device as AppleTV2,1
Preparing to upload limera1n exploit
Resetting device counters
Sending chunk headers
Sending exploit payload
Sending fake data
libusb:error [darwin_transfer_status] transfer error: timed out
Exploit sent
Reconnecting to device
libusb:error [darwin_close] USBDeviceClose: no connection to an IOService
Waiting 2 seconds for the device to pop up...
opening device 05ac:1227...
Uploading iBSS.k66ap.RELEASE.dfu to device
[==================================================] 100.0%
libusb:error [darwin_reset_device] ResetDevice: device not responding
libusb:error [darwin_close] USBDeviceClose: no connection to an IOService
Waiting 10 seconds for the device to pop up...
opening device 05ac:1281...
Setting to configuration 1
Setting to interface 0:0
Uploading kernelcache.release.k66 to device
[==================================================] 100.0%
libusb:error [darwin_transfer_status] transfer error: device not responding (value = 0xe00002ed)
Exiting libpois0n


以上
第九步驟完成


看看你是不是卡在這裡~~試試看吧

USB從頭到尾都是一直接著MAC的嘛?!

除了之中有一次需要重新插拔嘛?!

yukai_hung wrote:
我jb成功了,手法應...(恕刪)


所以是指
./tetheredboot -i iBSS.k66ap.RELEASE.dfu -k kernelcache.release.k66
之後按enter~


然後在終端機上要顯示出這段


Waiting for device to enter DFU mode
opening device 05ac:1281...
Setting to configuration 1
Setting to interface 0:0
Device must be in DFU mode to continue


才是正確的嗎?!

可是我都是出現錯誤訊息:

dyld: unknown required load command 0x80000022
Trace/BPT trap

一直無法順利下去…

不知道有沒有大大可以幫忙的?!

感謝上面兩位大大…

★這傢洗艾台玩啦!☆
不知道是不是microUSB cable的緣故

我是用一般傳輸用的 USB to miniUSB cable

再自己買顆miniUSB to microUSB adapter裝上去

一些手機附的通常有跳線

--------------------------------------------
不然先修復權限看看吧
我也是一直失敗,不過我是敗在
6. Restore the AppleTV to the ~/Desktop/tethered/AppleTV2,1_4.2.1_8C154_Custom_Restore.ipsw firmware (your AppleTV SHOULD be in DFU mode after finishing up with PwnageTool)
一直都沒辦法restore回去耶?錯誤訊息有6011或是21?
如果要再重做的話可以直接進入DFU來restore步驟五做好的Restore image嗎?還是要全部重做?


7. Unplug and then replug the USB, after the AppleTV has finished started up (will be blinking steadily), plug in the power cable

這是說前面的步驟Apple TV都不用插電嗎?


請有成功的網友指點一下,感謝!




  • 4
評分
複製連結