NOTE: it will loop a complaint re: DFU mode, just ignore this, once you are finished getting in DFU mode tetheredboot will take over.
9. MANUALLY put the AppleTV in DFU (*DO NOT USE PWNAGETOOL*)
- Disconnect power cable and connect your Apple TV with your computer via microUSB - Now reboot your Apple TV by holding down Menu + Down buttons together for around 6 seconds. - After reboot, immediately hold Menu + Play until you see the message in iTunes saying that Apple TV in recovery mode is detected
Waiting for device to enter DFU mode opening device 05ac:1281... Setting to configuration 1 Setting to interface 0:0 Device must be in DFU mode to continue
就是顯示沒有進入DFU MODE~
此時快點apple remote的MENU和PLAY一起按~約五秒鐘 apple tv的閃燈就會變超快的~顯示已經進入了dfu了 接下來就會顯示這些~
Found device in DFU mode Checking if device is compatible with this jailbreak Checking the device type Identified device as AppleTV2,1 Preparing to upload limera1n exploit Resetting device counters Sending chunk headers Sending exploit payload Sending fake data libusb:error [darwin_transfer_status] transfer error: timed out Exploit sent Reconnecting to device libusb:error [darwin_close] USBDeviceClose: no connection to an IOService Waiting 2 seconds for the device to pop up... opening device 05ac:1227... Uploading iBSS.k66ap.RELEASE.dfu to device [==================================================] 100.0% libusb:error [darwin_reset_device] ResetDevice: device not responding libusb:error [darwin_close] USBDeviceClose: no connection to an IOService Waiting 10 seconds for the device to pop up... opening device 05ac:1281... Setting to configuration 1 Setting to interface 0:0 Uploading kernelcache.release.k66 to device [==================================================] 100.0% libusb:error [darwin_transfer_status] transfer error: device not responding (value = 0xe00002ed) Exiting libpois0n
Waiting for device to enter DFU mode opening device 05ac:1281... Setting to configuration 1 Setting to interface 0:0 Device must be in DFU mode to continue
我也是一直失敗,不過我是敗在 6. Restore the AppleTV to the ~/Desktop/tethered/AppleTV2,1_4.2.1_8C154_Custom_Restore.ipsw firmware (your AppleTV SHOULD be in DFU mode after finishing up with PwnageTool) 一直都沒辦法restore回去耶?錯誤訊息有6011或是21? 如果要再重做的話可以直接進入DFU來restore步驟五做好的Restore image嗎?還是要全部重做?
7. Unplug and then replug the USB, after the AppleTV has finished started up (will be blinking steadily), plug in the power cable