請問自行買電池回來更換，電量都停留在50%，不上也不下，翻硬體資訊發現電池版本異常，這要怎麼處理，謝謝各位
不過我上網辜狗看到一個美國人教了解決方法,
-----------
eksine USA Level 1 | View eksine's posts
Post on 2017/7/6 03:16
The problem is not the software. the way you fix it is take off the back plate, remove all the tiny Philips screws and remove the hold down backing plate, and take a piece of paper and fold it 2 or 3 times and place it on the black foam piece that the battery connector is on the top of the battery, that's the battery connector connecting the battery to the phone electronic board. the problem is the connection is loose. what you are doing is creating a shim to push the connector in more. you could use electrical tape but paper works ok and you can control how much pressure to apply. do not use too thick of a piece for the shim or you would bulge out the hold down backing plate.
--------------
感謝這位美國的eksine大大,
具體解決方法是在於電池的插頭跟機體面板的接觸不良所造成，
所以解決方法就是在電池接頭上方的黑色泡棉處放置
摺好的紙版或是捲好的防電布，
我個人覺得紙板不是很安全剛好手邊又有電火布，
就自己捲了大概長度５ｍｍ，寬度２ｍｍ，高度１．５ｍｍ的電火布小塊，
用剪刀把上下收邊然後放入電池黑色泡棉布上方然後把ｓｉｍ卡跟ｓｄ卡條蓋上去鎖起來，
再把機殼裝好開機，
再沒有對電池接頭放電火布加壓之前機體判斷新電池是null 000ffffffff
然後充電也好，使用也好，電量都顯示５０％
而且判斷電池損耗的ＡＰＰ也抓不到電量消耗數據，
電火布放置加壓後，
硬體的電池判定變成z2c3 01040005 1524
電池型號有抓出來了，
使用上的電量損耗ａｐｐ也抓到了，
充電也能充到一百％了，
如果01這邊發問的還沒解決問題可以試試看.
內文搜尋
從 APP 打開
X