http://www.anandtech.com/show/6747/htc-one-review
這個評測有花時間研究，簡直論文一樣
------------------------------------------
HTC begins construction of the One from a solid piece of aluminum. Two hundred minutes of CNC cuts later, a finished One chassis emerges. Plastic gets injected into the chassis between cuts during machining for the antenna bands and side of the case, which also gets machined. The result is HTC’s “zero-gap” construction which – as the name implies – really has no gaps between aluminum and polymer at all for those unibody parts.
HTC的機殼開始是從一整塊鋁，經過CNC削減兩百分鐘後，將鋁製成成品鋁機殼。
然後經由塑料射出射入加工鋁殼中的縫隙 (放入的天線的背面頻帶及側面)，這樣後蓋就完工了。
經過此製程的結果是造就出HTC獨特的“零間隙”(無縫)殼子 。 顧名思義 - 真的有鋁和聚合物緊密成為一體且沒有間隙的一體式機身(無縫)。 ....(所以HTC沒說謊，是真的無縫隙，而且製程難度超高，CNC就算了，還要結合塑膠射出)
.....(然後作者繼續讚美一下，接下又有以下敘述)
The only place there’s some fit and finish weakness is in the top and bottom front facing aluminum pieces, which aren’t part of the CNC machining that the rest of the chassis undergoes. Instead I suspect these are adhered onto the rest of the phone after the display, PCB, and battery are inserted into the back case. The result is that there is unfortunately a small gap between where those parts come together, but we’re talking about a tiny, tiny gap.
唯一比較可能不密合的地方，是正面上下鋁片(兩個喇叭殼)。
這兩個鋁殼不屬於底盤經CNC機床加工的一部分。
相反，我懷疑這兩片鋁殼是與電話的其餘部分(顯示，印刷電路板和電池的背面)結合後的然後整個插入底部機殼。其結果遺憾的是，那些零件與底蓋結合後還是會有一點小小的差距，但我們談論的是一個很小，很小的差距。
----------------------------------------
由此可知有真的很小的差距是一點都不影響品質(因整塊都結合在一起，才放在無縫殼內)不需要用放大鏡放大抹黑啊!
相反的如此高難度又創新的製程，真的是值得去體驗一下觸感
[結論]一點點微不足道的小點，也被抹黑放大成買了就會死掉的樣子....真是辛苦那些被 [黑暗行銷手法的商業帝國主義公司] 奴役的工讀生們...
內文搜尋
從 APP 打開
X