RAW按鈕可支援自定義了.
我已閱讀過並同意遵守討論區規則
RAW按鈕可支援自定義了.
我已閱讀過並同意遵守討論區規則
RAW按鈕可支援自定義了.
我已閱讀過並同意遵守討論區規則
2012-03-21 15:48 發佈
http://www.fujifilm.com/support/digital_cameras/software/firmware/x/finepix_x100/index.html
The firmware update Ver.1.20 incorporates the following issues.
After updating into this version of the firmware, some new functions will be added and further improvements will be observed. Those are shown as "Improved items" below.
For operation of newly added functions, which are described as following item 1 to 6, please download PDF data issued as "FinePix X100 New Feature Guide".
Please check them in detail.
1.Some functions, which can be set to "Fn" button and shown as "Fn BUTTON" in SET-UP menu, can be also set to RAW button. After pressing the command dial to right in the SET-UP menu of "Fn BUTTON", "Fn" and "RAW" are displayed and each of selectable them,
Also, by holding down RAW button for more than 3 seconds, same type of selection menu for RAW button is displayed, just as short-cut procedure.
2.By selecting in "ISO" menu in the shooting menu, either ISO sensitivity value or "ISO AUTO CONTROL" can be selected.
3.When AF MODE is set to "AREA" in Single AF (AF-S) mode, active focus point is zoomed in (magnified to approx 5x) by pressing center of the command control.
4.When "ND FILTER" is set to "Fn" button or "RAW" button, setting between ON ("ND" is displayed) or OFF ("ND" is NOT displayed) can be changeable by pressing "Fn" button or "RAW" button, which is set for "ND FILTER".
5.When the image is shot with vertical angle of the camera and played back the shot in the LCD, the image is displayed with whole area of LCD even after pressing "playback zoom in" button.
6.When the human face is shot, the detected face is displayed during the playing back, and pressing the command dial to down, detected face is magnified during displaying.
7.AE control system and AF performance including AF speed has been improved for movie recording mode
roma_batis wrote:
太好了!!終於......(恕刪)
按Menu會出現感光度ISO和ISO自動控制不等於在感光度ISO中可以有AUTO. 所以在便利性上, 還是有差一截. 因為在fn設定成iso時, 還是不會出現auto!
內文搜尋
從 APP 打開
X