機器是DLINK-DIR600
作業系統是WIN 10
我是在外面租房子的~主機在機房我沒辦法動
原本剛搬來的時候可以進入也都設定好了
但今天想重新設定發現打192.168.0.1卻都進不去
然後我按了分享器後面的RESET等重啟後
還是進不去~但神奇的是不用設定也能連線
但我是無限分享器~因為我按了RESET
結果原本設定的無線網路重置了!!
但是我進不去設定也導致
我沒有辦法重設WIFI的密碼
想請問是什麼原因~有辦法排除嗎?
還是主機那邊的問題?因為我剛搬來的時候
需要設定好分享器才能連線~現在重置後卻
不需要設定就能連線~我有什麼辦法可設定
我的WIFI密碼嗎?
如果WIFI變成開放式的誰都能連~那是否會有安全疑慮?
我該如何預防?
如果是主機設定的問題,那我可以把分享器拿到朋友家設定好WIFI密碼後
再拿回家用嗎?
Procedure for DIR series routers
1. Store a copy of the router firmware (.BIN) on the HDD of a local PC
2. Connect an Ethernet cable between one of the LAN ports on the rear of the router and the network port on the local PC
3. Configure the PC with a static IP address other than 192.168.0.1 (e.g. 192.168.0.5)
4. Power down the router and unplug the power cord
5. Press and hold the reset button on the rear of the router for 3 to 5 seconds and re-plug the power cord without releasing the reset button
6. Continue to hold the reset button until the amber power light keeps blinking on and off
7. Open a web browser and enter the following address: http://192.168.0.1/
8. Wait for the D-Link Router Recovery Mode page to load (See Exhibit 1 below)
9. Using the Choose File button, select the router firmware stored on the local PC and then press Upload
10. After the firmware successfully loads, a Success page will display
11.If the Success page fails to display, then repeat steps 3 through 9

內文搜尋

X