• 3

[起死回生]IBM ServerRAID 4Mx 高階磁碟陣列卡維修實況

其實要修機器只要有心都可以修

只是.............

重點在於........

是否可以停機那麼久來作維護


由於不想停機影響公司作業

所以已經習慣性的多買一些當備品

server容易掛的東西一定要成雙(HD,POWER,網卡)

你好 本人也遇到4mx卡 掉點以後無法抓到的情況 本人的環境是x360+4mx+exp300雙機系統
一塊4mx 停電以後就找不到了 本人測試電池電壓4.88 另一塊2008年12月29號関機 2009年1月3號開機就報pci錯誤 4mx就抓不到了 我把4mx的電池拔掉就能認到 找了另一個x360機器上4mx 電池換過來也能認到 抓不到的4mx卡在x345的服務器上能認到 我暈死了 難道必須換電池還是我的卡的故障和你的不一樣 期待回復 mail:rtm009@gmail.com 本人在北京

本人看有關4mx電池的文章說x360 x365的機器會自動屏蔽故障卡 本人e文不好 不知道到底怎麽囘事兒
ServeRAID battery failures and their effect on host systems - Servers
RETAIN tip: H18443

Additional information
There are different ways in which systems behave when the battery is approaching its end of usable life. In
many cases, the battery no longer charges to its specified voltage as it reaches the end of its usable life.
This is detected by the ServeRAID controller and an alert is generated by the ServeRAID Manager to
indicate that the FRU battery needs to be replaced.
In other cases, as the battery fails, the charging circuit on the ServeRAID controller draws a short current
surge from the PCI/PCI-X Slot. The PCI/PCI-X current-limiting circuit on some servers, like the xSeries 360
and xSeries365, turns off power to the PCI Slot and the controller is no longer seen at POST.
This behavior can be confirmed by watching the controller in the Slot at power on. The Slot powers up,
indicated by the green power LED, then shortly after, powers off with the amber warning LED lit. On
systems without PCI-X "current limiting" circuitry, the controller may return a "controller failure" or "battery
failure" message during POST, depending on the status of the battery.
rtm009 wrote:
ServeRAID battery failures and their effect on host systems - Servers

RETAIN tip: H18443...(恕刪)



沒有錯~~~~


請依照我的教學來更換電池就可以了~~~



阿胖技研,專研資訊相關技術!

wst2080 wrote:


請依照我的教學來更換電池就可以了~~~


不過原來的電池可能是鎳鎘改成鎳氫MH會有一點差異。
兩者的充放電特性有差異。

不知道有何影響?
earl258 wrote:
不過原來的電池可能是...(恕刪)


差異不大~~~

電壓相符就可以了~~~

畢竟BBU是需要電力來提供給RAID使用~~~

至於充放電的方式,其實沒有太大的差別~~

只是 鎳氫 或者 鎳鎘 是電池的差異霸了!

只要符合充電放電的標準就可以了~~~~

阿胖技研,專研資訊相關技術!
大大真是太厲害了!真有心思拆解...
小弟通常都只做到固障偵測/排除而已,還沒做到維修
看來應該是去進修一下電子相關知識了...
earl258 wrote:
兩者的充放電特性有差異。
不知道有何影響?

NiCd 和 NiMh 都是用定電流方式充電, 所以沒有關係.
NiCd 的瞬間放電的電流可以比較大, 所以用在有馬達的裝置上才會有差.

本文提及的卡應該不會瞬間吃電大, 所以用 NiMh 也沒關係.

Li-Ion 電池主要用定電壓方式充電, 充飽到某個程度時再切換成定電流充電.
與 NiCd/NiMh 充電方式不同.
-- The same lotus of our clime blooms here......
wst2080 wrote:
這個IC標號為 M40Z300WMH6 ...

NVRAM Supervisor = Non-Volatile RAM 控制器

一般的 RAM 如果移除電源, 內容就會消失.
NVRAM 是指電源移除後, 這種 RAM 內部的資料仍會留存.(所以稱 "NV")

單顆的 NVRAM 是內部有 RAM 和 EEPROM.
當電源失效時, 會送出一個信號給 NVRAM, 它自己趕緊把內部的 RAM 內容寫到 EEPROM 內.
下次電源來了後, 再把 EEPROM 的內容填回 RAM 去. 宛如 RAM 內容未消失般.
(一般是 SAVE 和 RESTORE 兩個信號)

但 NVRAM 比較貴或容量不大, 所以 這顆 IC + 黃色電池 + RAM(需 CMOS 製程, 取其耗電小)
搭配起來就等同 NVRAM 了.


wst2080 wrote:
標號為 M4Z32-BR00SH1 的電池

查了一下, 內部結構是:


很簡單, 就是一個鋰電池而已. 看規格是 2.8V, 120mAh.
如果壞了或沒電而且買不到, 換上一個 CR2025 (3V, 165mAh. 工程計算機常用) 的電池就可以.
-- The same lotus of our clime blooms here......
可以考慮把蓄電池換成電雙層電容器(高容量). 這類電容器不是靠化學反應儲存能量因此壽命比蓄電池長多了.
http://en.wikipedia.org/wiki/Supercapacitor



  • 3
內文搜尋
X
評分
評分
複製連結
Mobile01提醒您
您目前瀏覽的是行動版網頁
是否切換到電腦版網頁呢?