請問目前原廠有提供TRIM軟體的SSD?

因為舊XP 32bit電腦主機板故障要更新硬體

其中OS的HDD想要更換SSD

大概發現幾個問題

一個是移機OEM需換成VKL序號問題,否則會造成XP鎖死

另一個大概就是VISTA以下的系統使用SSD都不支援TRIM的問題(從WIN7後才開始支援)



目前網路查到一些SSD的原廠軟件有支持手動TRIM

INTEL/威剛/SANDISK/WD/三星

較近年的詳細資訊請爬
https://msfn.org/board/topic/173482-can-windows-xp-pro-x86-safely-trim-an-ssd/

習慣用美光 但不確定美光有無支援TRIM 看了美光官網的軟體是沒有
而美光網頁寫說 美光的SSD都是在默認無TRIM下開發的
所以沒TRIM的OS也請放心使用
所以應該是有一些面對慢慢降速的相應設計在

另外XP安裝程式不會對SSD做4K對齊
所以你必須將SSD先插到WIN7之後的系統執行分區以及格式化
Assuming you're using NTFS file system, your only concern with Windows XP x86 or x64 is creating an aligned partition. Once that is done, the subsequent formatting and OS install can be handled by XP. Probably lots of tools can do this, here's one way to go about it, off the top of my head...

Use diskpart in Vista repair disk or Windows 7 to create the aligned partition (the offset). Hook up your SSD to the Windows 7 computer, open command prompt and enter "diskpart.exe" without the quotes. Enter "List disks" and identify your SSD. If it is, for instance, disk 1, enter "Select disk 1". Then enter "list partitions" and it will list the existing partitions on that SSD (or say that there are none, if the SSD is new or blank). If it lists a partition, enter "delete partition" and it will acknowledge the deletion. Then, for example, enter "create partition primary align=1024 size=90000" to create a 90GB partition. Diskpart should acknowlege the creation of your partition, and you're done. You're ready to install XP on that partition, including formatting.

(The reason for using diskpart with Windows 7 is that Windows 7 OS Disk Management will include an extra header partition peculiar to Windows 7, and botch an XP installation)

I use a little tool called AlignScript/SSDalign after the fact, to verify that the partition is properly aligned.
by_https://msfn.org/board/topic/173482-can-windows-xp-pro-x86-safely-trim-an-ssd/page/6/
不過4K對齊這不是使用AMOIE之類的程式就可以辦到了嗎?但不知道有沒有XP 32位元版的就不知道了
如果手頭上有台WIN7以後的電腦可以這樣操作