After a firmware update, 9260-series RAID controllers do not complete POST when used with the Gigabyte GA-X58A-UD9 motherboard. At this time, the workaround is to downgrade to an older version of firmware. Due to NVDATA changes in our latest release, a special workaround is required for downgrading firmware. Follow the instructions below and use the attached image to downgrade.
Downgrade instructions:
1. Remove the MegaRAID controller from the system
2. Disable the PCI slot scan in system BIOS
3. Insert the MegaRAID controller into the slot where the PCI slot scan was disabled and boot to DOS
4. Use "MegaCli -adpm0flash -f mr2108fw.rom" to reflash this firmware image (Mode 0 flash MUST be done in DOS)
5. Reboot the system to either the OS or DOS
5. Use "MegaCli -adpfwflash -f <older fw file name> -noverchk -a0" to flash the older firmware version
6. Use "MegaCLI -facdefset -a0" to load the factory defaults
7. Reboot the system and the MegaRAID controller should be recovered
http://kb.lsi.com/KnowledgebaseArticle16086.aspx
這是很糟糕的問題....
downtodo wrote:
基本上如果沒有特殊用...(恕刪)
先撇開你SSD相容性不談..
畢竟目前SSD support作最好的就是LSI..
"再加上主機板上的RAID與ARC-1680RAID卡無法同時運行,選擇主機板RAID ARC-1680 RAID卡就無法使用,真是花錢找罪受,三萬多的卡就如此更何況便宜的RAID卡,基本上如果沒有特殊用途,我是不建議買RAID卡."
你這個是典型的IRQ問題...
就算是Server board也有機會遇到...
解決方式可能有幾種...
1. 可能會依照boot order來載入...
2. 從RAID HBA設計上處理, 這我在HPT的卡有見過這種設計...
3. BIOS上可能會提供類似Option ROM Scan項目, 可以設定成Add-on Card優先載入或著Onboard Option ROM
4. 如果插兩張以上RAID HBA在加上Onboard RAID, 導致亂搶IRQ, 除了可以設定Option ROM Scan順序之外, 有些主機板會針對slot的Option ROM提供Enable/Disable項目...
至少我在Supermicro這類Server board照樣還是碰的到這種鳥問題...
只是這類板子在BIOS可以作一些設定躲開這些鳥問題...
內文搜尋
從 APP 打開
X