Freshness wrote:
gh frequency support不要選自動，選 level 3看看，應該有Level1/2/3可以選，你都試試看。記憶體倍頻，手動設為36。
感謝您，我倍頻選32可以超了，但是選32以上，電腦都會BBB三聲(大概重開2次)，之後就變成預設的26了。
今天我在嘗試看看Level3再改成36看看。
想順便請教一下，gh frequency support 調整可以做什麼用呢?
說明書是說相容的功能，往入有找到使用者分享:
This was actually easy to figure out - I just enabled all three and each time checked in Ryzen master. It's just a quick toggle for Fabric speeds and possibly voltages - I did not check voltages - but can confirm the manual fabric speeds that were adjusted. Level 1 sets your fabric (uclk) to 1600mhz to support DDR4 3200, Level 2 sets it at 1700mhz to support DDR4 3400 and Level 3 obviously is the magic 1800mhz to support DDR3600. Auto works fine on my board using DDR4 3600, sets the fabric correctly to 1800mhz
內文搜尋
從 APP 打開
X