• 5

HTC Touch Cruise 可以用 Android 2.1 (Eclair)了。

請問出現以下問題要如何解決
#3 persistant property ... error 2



If you receive the following error:


V O G U E A N D R O I D [some number] init: Unable to open persistant property directory /data/property error: 2





Then your data file cannot be mounted



Use the data.img from the bottom of this post; Reboot, unzip and place the data.img in the /sdcard/andboot folder and start over (yes you will need to reinstall the system)


This time DO NOT WIPE DATA
poy大你好

今天循著步驟執行
拿一張2g卡格成3個區(用Paragon Partition Manager 10)
也將檔案放到記憶卡中
進行到第8步驟
按run後就整個黑屏
按鍵及電源鍵都無回應必須reset才能重開機
試了幾次都是同樣結果
不知道是不是哪個步驟漏了或錯了

andboot資料夾該如何確認是放到格成fat32的磁區中
我是直接複製到記憶卡
趙 拿 飛
squall39 wrote:
wifi_updat...(恕刪)



網路上找到的試試看
http://forum.xda-developers.com/showthread.php?t=653871
-------------------------------------------------------------------------------------------------
...
...
...
4 - Rename to androidupdate.tar and put in andboot folder on sdcard;

5 - Reboot phone and go to install menu;

6 - Select install update and then press yes and wait;

7 - Select fix permissions and wait;

8 - Remove battery and put it back;

9 - Turn on phone;

10 - Enjoy!!!
不好意思,請教一下

這段
"打開 default.txt ,在倒數第二行的 set cmdline 參數中加入 board-htcpolaris.panel_type=1 後存檔"

是指將這段

set cmdline "board-htcpolaris.panel_type=1 ppp.nostart=0 pm.sleep_mode=1 mddi.width=240 mddi.height=320 no_console_suspend clock-7x00.mddi=0xa51" boot

改成


set cmdline "board-htcpolaris.panel_type=1 board-htcpolaris.panel_type=1 board-htcpolaris.panel_type=1 ppp.nostart=0 pm.sleep_mode=1 mddi.width=240 mddi.height=320 no_console_suspend clock-7x00.mddi=0xa51" boot


請問是這樣子改嗎???
請指教,謝謝~~
請問版大
我安裝到一半出現以下訊息....
unable to open persistent property directory /data/property erron:2
這該如何解決阿?
  • 5
內文搜尋
X
評分
評分
複製連結
Mobile01提醒您
您目前瀏覽的是行動版網頁
是否切換到電腦版網頁呢?