想把家裡的層板燈壞掉的換新的T5燈具上去 .
網路上找到的圖片Adreno 的串連接口跟現有層板燈(T8 鋁架內含安定器 , 很便宜那種 )
燈具的連結線接口一樣 , 看起來只要爬上去作交換就好 . 不知道對不對?
至於Vector 比較便宜 , 而且我也不需要燈罩與開關 , 但是找不到這支的串連接口型式圖片 ?!
是否跟Adreno 那種接口一樣?
另外再確認Vector and Adreno 內建的安定器是預熱式的?
謝謝
全家照明 wrote:
Adreno 兩種確實是預熱型電子安定器...(恕刪)
錯誤!
飛利浦公司網站內的pdf檔, 第一頁就寫了
http://download.p4c.philips.com/l4bt/3/328726/328726_ffs_tzh.pdf
Flicker-free with instant start electronic operation
注意關鍵字"instant start"
再參考Wiki 關於電子安定器(Electrical ballast) (大陸用語:鎮流器)(閩南語:變電阿)
Instant start
An instant start ballast starts lamps without heating the cathodes at all by using high voltage (around 600 V). It is the most energy efficient type, but gives the least number of starts from a lamp as emissive oxides are blasted from the cold cathode surfaces each time the lamp is started. This is the best type for installations where lamps are not turned on and off very often.
Instant start 絕非預熱式!! 因為"without heating the cathodes at all "
真正預熱式是 Programmed start
A programmed-start ballast is a more advanced version of rapid start. This ballast applies power to the filaments first, then after a short delay to allow the cathodes to preheat, applies voltage to the lamps to strike an arc. This ballast gives the best life and most switch cycles from lamps, and so is preferred for applications with very frequent power cycling such as vision examination rooms and restrooms with a motion detector switch.
內文搜尋
從 APP 打開
X