insideccw wrote:
是否該入坑?...(恕刪)
基本上音軌中就有收錄or混入 音場
把他回放出來即可
推薦進入全系統調整處理這個境界
把系統上回放的誤差縮小
http://www.myav.com.tw/bbs/showthread.php?s=&threadid=20465155&pagenumber=1
供您參考看看
insideccw wrote:
補上擺位圖跟目前手動設定分頻點如下，因為小弟人在東南亞，這邊音響文化沒有像台灣這麼進步，只好自己來了...(恕刪)
建議擴大機裡的設定.
1.所有的喇叭都設定small.
2.所有喇叭的分頻點都調80hz.
3.重低音"背後"的分頻旋鈕也切在80hz,音量旋鈕切在80%∼90%的位置.
4.喇叭高音盡量"面向"皇帝位的耳朵高度.
5.擴大機的自動校正麥克風架在皇帝位的耳朵高度.
6.擴大機選擇重新校正,音壓,距離,EQ 這三項.
這樣弄完後,聽起來還是覺得哪裡不足時.
建議以這個調整的聲音為基底,
在以手動調整試試.
您也可以找販售器材給您的店家尋求技術支援
我是跟專業店家ups購買器材線材
ups有提供我技術支援的服務
3060Test Bench
Two channels driven continuously into 8-ohm loads:
0.1% distortion at 159.0 watts
1% distortion at 186.4 watts
Five channels driven continuously into 8-ohm loads:
0.1% distortion at 102.3 watts
1% distortion at 127.1 watts
Seven channels driven continuously into 8-ohm loads:
0.1% distortion at 52.2 watts
1% distortion at 53.6 watts
636 Two channels driven continuously into 8-ohm loads:
0.1% distortion at 114.1 watts
1% distortion at 134.1 watts
Five channels driven continuously into 8-ohm loads:
0.1% distortion at 80.2 watts
1% distortion at 95.6 watts
Seven channels driven continuously into 8-ohm loads:
0.1% distortion at 77.3 watts
1% distortion at 90.4 watts
你的前面又是落地的，建議分頻點最少設80
天空也是一樣
cnn wrote:
單純看價格差兩倍的...(恕刪)
A3060雖然二聲道功率較強,但在七聲道的功率衰退很快. 相較於NR636的二聲道功率雖然較弱,但七聲道功率衰退相對而言並不多.
順便參考Marantz SR7011的表現:
Two channels driven continuously into 8-ohm loads:
0.1% distortion at 138.7 watts
1% distortion at 169.1 watts
Five channels driven continuously into 8-ohm loads:
0.1% distortion at 104.9 watts
1% distortion at 117.0 watts
Seven channels driven continuously into 8-ohm loads:
0.1% distortion at 75.1 watts
1% distortion at 90.4 watts
再挑一台價格很平實的七聲道後級 Monolith 7 ($1500美金)來比,它強勁的出力就不是一般綜合環擴可以相比的:
Two channels driven continuously into 8-ohm loads:
0.1% distortion at 215.9 watts
1% distortion at 255.6 watts
Five channels driven continuously into 8-ohm loads:
0.1% distortion at 185.8 watts
1% distortion at 223.5 watts
Seven channels driven continuously into 8-ohm loads:
0.1% distortion at 178.5 watts
1% distortion at 211.9 watts
台灣NO1加油 wrote:
請問大大Monolith...(恕刪)
它被列為最佳性價比的器材之一,但我不知道台灣是否有引進?
https://read01.com/oMeBm3.html
Monte920 wrote:
A3060雖然二聲道...(恕刪)
若是要加後級，可參考另外一平價品牌outlaw ，7系列有平衡輸入
7500的測試數據
https://www.soundandvision.com/content/outlaw-audio-7500-5-channel-power-amplifier-measurements
This graph shows that the 7500’s left channel, with two channels driving 8-ohm loads continuously at 1 kHz, reached 0.1% distortion at 284.9 watts and 1% distortion at 342.3 watts. Into 4 ohms, the amplifier reached 0.1% distortion at 447.6 watts and 1% distortion at 492.8 watts.
With five channels driven continuously into 8-ohm loads, the AVR reached 0.1% distortion at 260.1 watts and 1% distortion at 301.1 watts. The manufacturer’s stated distortion of 0.03% was reached at 238.7 watts, which is actually higher than the spec'd 200Wpc at that distortion level with all channels driven.
台灣沒有進，要自尋管道
你的需求要先確定好，建議先試聽山葉的看看
insideccw wrote:
補上擺位圖跟目前手...(恕刪)
手動調整過, 可是沒有大略說一下調整哪些項目. 你的空間一邊偏空一邊靠牆
1.跑過自動音場調整後, 然後 Audio Delay 改多2ms試試看
2.把後環繞兩個喇叭轉成相對,不要用45度角
3.後環繞喇叭的高度若能降低, 就別掛得太高
包覆感是跟喇叭音量與擺放位置比較有相關, 除非你去買到很爛的大陸韓國製的環繞擴大機. 那種只會轟轟轟但聲音卻糊掉. 原則上Yamaha, Denon, Marantz, Onkyo都算是安全的選擇. 你改看看再決定是否要換Yamaha.
(PS:我是Yamaha環擴的愛用者.沒有很愛onkyo的聲音.聲音的厚度稍微比Yamaha Denon低了一些)
給你Yamaha日本官網上標準的喇叭擺位, 你可以參考用看看.
內文搜尋
從 APP 打開
X