Elliot3925 wrote:
電源插頭全部拔掉, (恕刪)

vexicy2000 wrote:
小弟不懂音響 之前都(恕刪)

vexicy2000 wrote:
小弟不懂音響 之前都(恕刪)

luxor_w wrote:
有試過嗎?回復到出廠(恕刪)

Troubleshooting Xeo with Hub / Connect

• Reset the Xeo speakers and Hub / Connect. Read more here.
• Make sure that any Wi-Fi receiving or sending devices are located at least 50 cm / 20 inches from both the Xeo speakers and from the Hub / Connect.
• Try using a different Zone setting on the speaker (Red / Green / Blue switch on the Xeo speaker).
• Try using a different ID setting on the Hub / Connect (A / B / C switch). After the change, remember to powercycle the speakers and then re-select the ID via the Xeo Master Remote Control.
• Only applies to Xeo 2, Xeo 4 / Xeo 6 do not support High Resolution Mode: Try changing the Connect from High Resolution to Multiroom Mode, and vice-versa. After the change, remember to powercycle the speakers.
• Make sure your digital source outputs a PCM stereo signal. Read more here.
• Double check if your source is playing and works in a different setup.
• If possible, try fixing available Wi-Fi networks to a specific frequency range. This frees up frequencies for the Connect. Please read the documentation of your wireless router for details.