userhere wrote:
I don't know your motherboard. But I had a dual-cpu motherboard.
I think you can check this:...(恕刪)
Thanks for your answer...
I could boot my PC without the terminator too!(by the way, I do not have terminator ^^||)
but you remind me that my CPUs are not the similar batch number would be a possible...
1.run at 66 mhz. Most motherboard uses a jumper to switch this. If It is a memory or cache problem, 66MHZ would be no problem.
2. Use ide harddisc. SCSI needs right cable and carefully settings. Old and wrong cables are the most common reasons. Using the hdtune or system log to check this harddisc.
Good luck!

X