汽車橡膠上白白的臘

想請問各位大大....
打蠟時,總會不小心打蠟打在汽車的橡膠部位,大家多怎麼去除它呢...
之前多用噴在輪胎上的那種牛X王的泡沫,噴在毛巾上用來擦,效果還不錯,不過下雨後或洗完車,
它又會跑出來,有人也說過用牙膏粉、去漬油、噴蠟等等...
各位大大是如何去除可惡的它呢.................
2008-10-08 15:34 發佈
文章關鍵字 汽車橡膠
沒辦法救了
要換新的
不然就勤洗車..每次橡膠都用皮革油上油蓋住
用油(硬)臘(手打)就不會發生了
林鳳營如果是人名 又是正妹 她的奶 我一定照三餐喝
eyegile wrote:
想請問各位大大......(恕刪)

面積不大的話用指甲就可摳掉.
再打上網拍ABC濃縮釉.
以後碰到再多次的腊也不會變白
國外有專用產品,請自行尋找購買方式



以下為該產品官方的產品說明:

Wax embedded into textured plastic bumpers and trim can make even a brand new vehicle look bad. Wax Blaster easily and quickly removes embedded wax. The sponge applicator scrubs the wax out. Just wipe off the cleaner with a dry cloth and the wax is gone!
Directions:

* Remove rubber applicator tip and remove red transport plug. Replace rubber applicator tip.
* Press sponge applicator directly onto surface to be cleaned until saturated with solution.
* Clean a small area at a time by rubbing sponge onto surface working solution into crevices.
* While area is still wet, wipe dry with a clean dry cloth, wiping in one direction only. Turn cloth with each pass to prevent reapplication of dissolved wax. If texture is extremely deep or if surface is heavily contaiminated, a second application may be required.

該產品的官方網頁

Vehicle Detailing Enthusiast Forum 為 OPT/WetGlaze/DANASE/WetGlaze2.0 之官方授權代表
你可以用皮革保養液喔!!
效果很強
感覺會跟新的一樣
但是
必須常常擦
要不然會變回來
只是不會像現在那麼嚴重
傷腦筋的問題~
碰到軟質橡膠的話,可能還好清理一些~
但是碰到表面較粗糙的硬質塑膠(如保桿),就很容易變成白白的一塊痕跡~
我都是用"飾條保養清潔劑"擦拭~
效果很不錯,又很容易買到,而且便宜用量省,給您參考一下~
http://www.meguiars.com.tw/index.php?_room=2&_subRoom=6&_action=detail&_page=1
最好在未變白之前
上2次ABC可耐2.3年以上
平日根本不用擔心
打腊不慎觸及或環境污染造或日晒造成的白化現象
內文搜尋
X
評分
評分
複製連結
Mobile01提醒您
您目前瀏覽的是行動版網頁
是否切換到電腦版網頁呢?