自從隨身耳機改成EX600後, 有一陣子都沒再觀望其它的耳道耳機
去年底跳水的X10在手上撐沒多久, 還是覺得EX600比較合口味
上個月入手冷門的EPH-100, 和EX600組合算不錯的搭配, 兩者都是中階耳道的強力候選
原以為這組合可以暫時不再更換耳道
(雖然對DBA-02 MKII有點心動, 但等過陣子價格合理後再說)
但這支ASG-1的購入卻打破了計劃, 手上的隨身用耳機勢必再度洗牌
話說冷門廠牌耳機一直是個人入手的最愛
在看到Aurisonics的官網介紹後, 忍不住就衝了一支
入手的ASG-1是非客製耳機, 有著類似客製耳機的造型, 可選擇客製耳塞
AS-1則是客製耳機, 除了外殼是用客製的耳模外, 還有其它選擇功能, 價格當然也不同
相同點是兩者都主打15mm的動圈單體, 可換線設計
除此外標榜Made in USA, 官網上還寫是hand-made
聲音部份當然光靠介紹是不準, 還是要自己聽過才知道合不合適
就這樣, 熬了幾天後總算收到ASG-1
-----------------------------------------------------------------------
規格:
* 8Hz - 25kHz frequency response
* 32ohm +/- 10% impedance @1kHz
* Sensitivity 121dB @ 1mW
* 15mm dynamic driver
* Standard S-M-L soft silicon replaceable tips
* The look and performance of a custom IEM
* Custom tips available for enhanced performance and fit
* Rugged design for professional use
1.0 - Original small foam internal pad, mechanical venting between driver and canal. Speakers tested then tested by listening only
1.1 - Foam surround internal pad around back ports of driver, drilled internal vent, better cover seal. Speakers tested, then tested on final with spectrum analyzer and listening test
1.1 with filters - Sent a few out with filters for people to try as well as sent filter material around for people to experiment with and comment
1.2 - Nozzle angle change, Left right markings added, internal bar in nozzle to stop foreign objects, increased internal vent size, Speaker standoff shelf internal change, speaker clearance change, utilized proprietary material around speaker for mid dampening, very slight amount of nozzle filter added. Speakers are pre-tested and qualified on spectrum analyzer only about half of them make the cut (tight tolerance), speaker inserted in the shell and cured, tested again for performance, dampening added and internal vent calibrated, spectrum analyzer again, final assembly, spectrum tested, nozzle filter inserted and tuned with spectrum analyzer, final human listening test to confirm all is as should be, visual inspection conducted then packaging.
-----------------------------------------------------------------------
這次開箱的主角ASG-1, 這張當然不是實體圖
目前的隨身耳機EPH-100/EX600, 交互使用
除了FedEx寄來的包裹外箱外沒有包裝, 類似客製耳機的外盒貼Aurisonics的貼紙
背面是ASG-1的規格介紹, 一樣是貼上去的
耳機呈霧狀透明, 背蓋有鎖螺絲
整體就製做成類似客製耳機模樣
耳機線是退後型插槽, 隱約可以看到商標的刻印
15mm動圈單體, 非常的明顯
耳道孔頗大, 直視可隱約見到單體
銀白色的耳機線, 搭配L型接頭
附贈的耳塞用起來有些雜音, 改用以前搭配SM3的雙節塞
以上
-----------------------------------------------------------------------
因為是動圈耳機, 原則上還是要等run過後才會穩定
目前粗略的使用感想
配戴非常簡單, 直接塞上就好
附屬的耳塞感覺不佳, 似乎特別容易產生摩擦的雜音, 在換過耳塞後改善
ASG-1搭配耳塞可能需要選擇
試過附屬/Sony Hybrid/Sensorcom這三種耳塞, 最後選擇了Sensorcom使用
聽感方面, 頗令我深思的聲音和走向
和手邊留著的EPH-100 EX600 1964-T HJE900都不相同
最明顯的是包覆感方面, 相當有特色
繼續run-in
