小弟的主機:P4 3.2GHT ATI1300PRO 1024MB-DDR2RAM
可否有成功進入的朋友 上傳幾張圖來看看
http://kororaa.org/files/manual/Kororaa-2005-Beta2-r1-Install-Manual-0.1.pdf
There is one install CD, which has two environments on it. One is x86, the other is AMD64.
If you are wanting to install an AMD64 version of either Kororaa or Gororaa, then you need to type kororaa64 at the install CD boot prompt.
If you are wanting to install the x86 version of either Kororaa or Gororaa then you just need press enter (or wait for the timeout). This loads the default 32bit environment by envoking kororaa.
Once the install CD has booted, just follow the instructions, ie. run the command kororaa to begin the install :)
NOTE: The "x86" versions can ONLY be installed on a system with a CPU that has SSE instruction support. This means Pentium3 (Celeron must be Coppermine core) or later (as per info on front page).
The AMD64 versions can be installed on any AMD 64bit cpu, including AMD64, Sempron64, Turion and Opteron.
大致上講說一定要P3以後的CPU，沒有裝過，不過如果你有問題
應該要把你的規格講清楚，最好拍張照
版上的其他高手才有辦法幫你
上面是這套軟體的顯示卡的支援表，可能你的顯示卡不支援或者需要另外手動設定才行......
我家的兩部電腦顯卡都是Nvidia剛好都沒問題^^"
whyhi wrote:
小弟下載回來是試一下 在光碟載入相關的驅動程式後 進入登入畫面時 主機卻出現逼逼聲 動也不動的 馬上趕緊按下電源鈕重開 就在也沒有在試囉 也不曉得到底是怎樣
小弟的主機:P4 3.2GHT ATI1300PRO 1024MB-DDR2RAM
可否有成功進入的朋友 上傳幾張圖來看看
內文搜尋
從 APP 打開
X