在PFC討論的滿熱烈的，不知其他家是否也有相同的模式，
應該有大大能破解吧?貼一下PFC的連結，
http://forum.pentaxfans.net/showthread.php?t=44397
K10D
原始出處:
http://forums.dpreview.com/forum ... mp;message=22013971
PFC相關討論:
http://forum.pentaxfans.net/showthread.php?t=44397
http://forum.pentaxfans.net/showthread.php?t=44438
Here's How-to-adjust-focus.
1. Your K10D' firmware version must be 1.10.
2. Test shot for focus trouble.
3. Turn the camera OFF.
While pressing [PLAY]+[OK], Turn the camera ON.
You can see firmware version on LCD screen.
4. Firmware version is appeared,
then press [Fn]->[Fn]->[INFO]->[MENU] within 5 seconds.
You get service menu!!!
5. by pressing [right key]
,Make DEBUG MODE to DEBUG MODE .
then press [OK].
(save and LCD will be black out)
6. Press [MENU] and go to SETUP tab.
then, Press [Up key], you can see TEST MODE.
7. Select AF TEST menu. now you have AF correction menu.
If you have Front-focusing, reduce the value.
If you have back-focusing, increase the value.
after adjust some value, press [OK] and quit out of setup menu.
8. TEST for focus, find out that focus is correct.
(repeat this from 6 for correct focus.)
9. Go to service menu(step 3,4).
Make DEBUG MODE to DEBUG MODE .
then press [OK].(save and LCD black out)
10. Go out and enjoy nice photos!!!
內文搜尋
從 APP 打開
X