[Quick Share] P900 change housing (with pics)

This is my first time posting
Hope this helps





This is the Red housing I changed earlier


a little closeup


Back view


To begin, you must first remove the Screws from the top corners (they are hidden under the plastic buttons)


Then remove the bottom screws


The original housing that I needed to change back b4 I sell it


Now take the top off (don't force it out !!! )


The top Speaker part is one of the hardest part to remove......well I kindda have to force it out


There are two screws hidden underneath the LCD, remove them before you take out the Body


These are the accessories you need to transfer to the new body


Also these stuffs....


a close up at the bottom board


another one


After I put them back in place and screw all the parts..... Ta Da !!
It is now back in Action !!!


Change back to the nice Blue Wallpapers



I hope this helps some of you who might need to change the housing of P900 or P910 in the future

As the aftermarket housings are not as expensive as it was, it can be a nice way to keep your P900 refresh

one strong advice is that DON'T change the keypad housing and Don't use the back cover that comes with the Non-OEM housing......because it fits VERY POORLY .......too bad

Also, the IrD cover is Extremely HARD to remove....so I use a tape to cover it instead.........well, as long as it keeps the dust away

Have FUN !!