Netgear Nighthawk R7000 Firmware Version 1.0.3.60 出爐, Log如下:
Firmware Version 1.0.3.60_1.1.27
Release note:
Fixed a potential memory leak issue which could cause WIFI connectivity loss.
Fixed a router reboot issue which is caused by an invalid DNS reply packet.
Fixed Downstream QoS issue which impacts normal traffic like VoIP or VPN.
Fixed a potential internet disconnect issue due to Bitcomet when it uses a large amount of network sessions.
個人已經更新, 尚無出現任何問題.
honda2 wrote:
我也已更新，但有幾個...(恕刪)
小弟我已從原廠韌體-->dd-wrt-->tomato 三邊來回刷了數十次了，完全沒有問題，但是刷機仍有風險，如果擔心因此會壞掉的話，還是別刷機了，用原廠韌體就好
Bridge function for Internet traffic看起來可以配合MOD用，還沒試...
R7000 Firmware Version 1.0.4.14
New Features & Enhancements:
• Supports remote access through the NETGEAR genie app.
NOTE : You must download the latest genie app in order to use remote access.
• Improves the Installation Wizard: Adds access point mode detection and new firmware checking and updating.
• Supports 6rd IPv6, IPv6 dual stack in PPPoE, and the manual IPv6 DNS setting.
• Supports VLAN/Bridge function for Internet traffic.
• Increases the maximum port forwarding rule to 64.
• Supports the traditional Chinese language.
• Supports the XFS file system.
內文搜尋
從 APP 打開
X