Draytek Vigor 2920n 正式支援IPv6

好消息,2920系列最新的韌體release了。
這個版號是3.6.0,正式的支援IPv6。
小弟稍後會詳細的分享各個功能,敬請期待!(如果家裡的小baby配合的話)


New Features(新功能)
Support IPv6.
支援IPv6
Support Smart Bandwidth Limit.
支援智慧型頻寬監控
Support DNS setting for each LAN subnet.
支援對個別區網設定DNS
Support LAN wired 802.1x.
支援區網802.1x認證功能
Support QoS retag.
支援QoS封包重新標籤功能

Improvement(功能加強)
Corrected: Static route doesn't work when multi-subnet is enabled.
Corrected: LAN1 will be displayed always while setting any static route for LAN2/3/4.
Corrected: Routing table display error in Diagnostic>>Routing Table page.
Corrected: Wrong LAN interface for static ARP is displayed.
Corrected: Both computers with the same VLAN cannot communicate for each other
when connecting to different switch.
Corrected: IGMP snooping problem.
Corrected: Can not open the Switch P2260 web configurator via External Device.
Corrected: The wireless client can't access internal network from another AP and return to Vigor2920 wireless LAN.
Corrected: DNS function does a force update even though no WAN IP changed.
Corrected: DHCP Relay via VPN tunnel can not work.
Corrected: Remove the incorrect log of PPP start (XXX), for we don't know who the incoming client is before authenticated by CHAP/PAP.
Corrected: IP Phones behind Vigor2920 cannot get registration after WAN Failover (Router sent UDP packets with source port 0).
Corrected: Cannot apply AES 192 and AES 256 on IPSec Security Method while the
customer chooses options of AES without Authentication in VPN and Remote Access
>> LAN to LAN page.
Corrected: Firewall can't block internal routing subnet packets.
Corrected: UCF Syslog cannot show HTTP or HTTPS.
Corrected: Can not show the FTP file list when Android phone connecting to Vigor2920 FTP server.
Corrected: ISDN Internet connection cannot work with miniVigor128.
Improved: Remove Ultrasurf from WUI.
Improved: Modify UCF/WCF block web page.
Improved: Support IP Route subnet parameters setting for TR-069.
Improved: Support firewall parameters setting for TR-069.
Improved: Support RADIUS parameters setting for TR-069.
Improved: Support Maintenance >> SysLog / Mail Alert Setup parameters setting for TR-069.
Improved: Modify the default pool size of LAN DHCP server from 50 to 150.
Improved: Online Status shows error Secondary DNS value.
Improved: Improve VPN Profile WUI.
Improved: Improve Samba with MacOS X.
Improved: Modify the Telnet command of "ip arp accept <0/1/2/3/status>" to allow the ARP REPLY which Target's MAC address does not equal to Ethernet source MAC address.
Improved: Enhance VoIP QoS.
Improved: Add new DDNS provider (UBDdns, Oray, and Peanut Shell).
Improved: Support modems such as ZTE K3806, and MF192, and MF190J, QT-R220,
LG VL600 LTE, LTE Yota LU150.
Improved: Add a telnet command for VPN packets going through by NAT or not when
VPN disconnects.
vpn pass2nat <on/off>
2012-07-05 12:13 發佈
你好,請問有載點嗎?我在台灣居易找不到,美國居易要下載又會轉會台灣!
irsjx2vxo3ne3k84dr1dz4,r4pe8bez3/4ne3bq4bew2j92gea jx4hq me-2d8 e3hy4hi2ty k84!
找到了,下載中^^來去研究一下ipv6!
聽說設定以後youtube會比較順!
irsjx2vxo3ne3k84dr1dz4,r4pe8bez3/4ne3bq4bew2j92gea jx4hq me-2d8 e3hy4hi2ty k84!
derliang wrote:
補充一下檔案的連結:...(恕刪)


升級至 3.6.0 firmware 後, Vigor 2020n 這二天連續發生死機的問題, 不管從內網及外網都無法連線進入, Internet 都是斷線的狀態, 只能再重啟電源. 這種情況真的很少見, 在更新前使用 3.6.0RC firmware 都還不曾發生, 只能再觀察看看.
FB: Pctine

pctine wrote:
升級至 3.6.0 ...(恕刪)


我是設定排程每天凌晨四點重新開機,穩定度倒還好。
但我有發現有時PPPoE與PPP會斷線重連,所以出現連線時間比開機時間短的現象。
這台好像已經有點老態了
irsjx2vxo3ne3k84dr1dz4,r4pe8bez3/4ne3bq4bew2j92gea jx4hq me-2d8 e3hy4hi2ty k84!

derliang wrote:
我是設定排程每天凌晨...(恕刪)


我都忘了這台有排程自動重新開機的功能. 至於你提到的 NAT throughput & QoS 的問題, 因為我自家用沒有啟用 QoS & session control, 所以感覺使用上也還 ok.
FB: Pctine
內文搜尋
X
評分
評分
複製連結
Mobile01提醒您
您目前瀏覽的是行動版網頁
是否切換到電腦版網頁呢?